Prusa i3 - Spare parts

der er velegnet til alle desktop FDM-printere

3DE MAX PLA har en øget slagstyrke på op til 9 gange i forhold til den almindelige PLA og er 20% ​​mere hård end ABS

Due to a low shrinkage factor

FLUX - Charcoal Filter Replacement - Beam Air Creality 3D - Ender-3 MAX - Reservedel Prusa i3 - Spare partsCharcoal Filter for your Beam Air It is recommended that the charcoal filter be replaced every 300 600 hours. Remember to also replace the other filters on time: See 3D Expert's selection of laser accessories here * Pre Filter (10 30 hours) * Medium efficiency filter (50 150 hours) * H13 HEPA filter (100 200 hours) * Charcoal filter (300 600 hours) Remove the filters: Open the top cover of the filter and remove the box from inside. Then take out the